Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM

AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here



DESCRIPTION
  1. Automatic headlight beam level control system data and the Diagnostic Trouble Codes (DTCs) can be read from the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the intelligent tester to check for malfunctions and to repair it.


CHECK DLC3
  1. Check the DLC3 (Click here).


INSPECT AUXILIARY BATTERY VOLTAGE
  1. Measure the auxiliary battery voltage with the power switch off.

    Standard Voltage:
    11 to 14 V

    If the voltage is below 11 V, recharge or replace the auxiliary battery.


DIAGNOSIS SYSTEM
  1. If the automatic headlight beam level control system malfunctions, "Check Headlight System" is displayed on the multi-information display.

    HINT:
    1. In this case, the headlight leveling ECU assembly stores DTCs (Click here).
    2. When the system returns to normal, "Check Headlight System" is no longer displayed on the multi-information display.