LIGHTING SYSTEM > DATA LIST / ACTIVE TEST |
| DATA LIST |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / (desired system) / Data List.
Read the Data List according to the display on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Dimmer SW | Dimmer switch high position signal/ON or OFF | ON: Dimmer switch in high or high flash position OFF: Dimmer switch in low position | - |
| Passing Light SW | Dimmer switch high flash position (pass) signal/ON or OFF | ON: Dimmer switch in high flash position OFF: Dimmer switch not in high flash position | - |
| Rear Fog Light SW*1 | Rear fog light switch signal/ON or OFF | ON: Rear fog light switch on OFF: Rear fog light switch off | - |
| Front Fog Light SW | Front fog light switch signal/ON or OFF | ON: Front fog light switch on OFF: Front fog light switch off | - |
| Auto Light SW | Light control switch AUTO position signal/ON or OFF | ON: Light control switch in AUTO position OFF: Light control switch not in AUTO position | - |
| Head Light SW (Head) | Light control switch head position signal/ON or OFF | ON: Light control switch in head position OFF: Light control switch not in head position | - |
| Head Light SW (Tail) | Light control switch tail position signal/ON or OFF | ON: Light control switch in tail or head position OFF: Light control switch in neither tail nor head position | - |
| Illumination Rate Info | Illumination rate information/0.00 ms. to 2162.65 ms. | Value is output according to ambient light levels | - |
| Response Time | Delay timing of lighting the taillights when the automatic light control sensor detects brightness change/Normal or Long | Customize setting displayed | - |
| Sensitivity | Sensitivity of the automatic light control system/Light2, Light1, Normal, Dark1 or Dark2 | Customize setting displayed | - |
| Disp Ex ON Sen | Ambient brightness level required to dim display lights (combination meter, navigation display etc.)/Light2, Light1, Normal, Dark1 or Dark2 | Customize setting displayed | - |
| Disp Ex OFF Sen | Ambient brightness level required to cancel dimming display lights (combination meter, navigation display etc.)/Light2, Light1, Normal, Dark1 or Dark2 | Customize setting displayed | - |
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Turn Signal Switch (Right) | Turn signal switch (Right) signal/ON or OFF | ON: Turn signal switch (Right) on OFF: Turn signal switch (Right) off | - |
| Turn Signal Switch (Left) | Turn signal switch (Left) signal/ON or OFF | ON: Turn signal switch (Left) on OFF: Turn signal switch (Left) off | - |
| Hazard Flasher Switch | Hazard switch signal/ON or OFF | ON: Hazard switch on OFF: Hazard switch off | - |
| ACTIVE TEST |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Active Test.
Perform the Active Test according to the display on the intelligent tester.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Taillight Relay | Taillight relay | ON/OFF | - |
| Headlight Relay | Headlight relays | ON/OFF | - |
| Head Light Hi | High beam headlights | ON/OFF | - |
| Front Fog Light Relay | Front fog light relay | ON/OFF | Light control switch is in tail position |
| Rear Fog Light Relay*1 | Rear fog light relay | ON/OFF | Light control switch is in tail position |
| Dimmer Signal | Dimmer signal | ON/OFF | - |