Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM

AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM > FAIL-SAFE CHART

for Preparation Click here



AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM
  1. The headlight leveling ECU assembly operates in fail-safe mode if an abnormal condition such as those listed below has been detected, and keep the last low beam status.

    Item
    Abnormality Detection Condition
    Return Condition
    Multi-information Display
    Height control sensor power source voltage
    Abnormal height control sensor power source voltage (4.6 V or less, or 6.25 V or more) is detected.
    Abnormal voltage is not detected for 5 seconds consecutively
    "Check Headlight System" is displayed.
    Height control sensor signal voltage
    Abnormal height control sensor signal voltage (0.25 V or less, or 4.75 V or more) is detected.
    High power source voltage
    Abnormal high IG supply voltage (18.5 V or more) is detected.
    Voltage of 17.5 V or less is detected
    "Check Headlight System" is not displayed.
    Low power source voltage
    Abnormal low IG supply voltage (9.0 V or less) is detected.
    Voltage of 9.3 V or more is detected for 0.1 seconds consecutively
    "Check Headlight System" is not displayed.
    Reset while running
    Reset by a temporary loss of power etc. while driving.
    Vehicle is stopped
    "Check Headlight System" is not displayed.