Home › Drivetrain › P314 HYBRID TRANSMISSION / TRANSAXLE › SHIFT LEVER POSITION SENSOR

SHIFT LEVER POSITION SENSOR > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH


2. REMOVE ENGINE UNDER COVER LH


3. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH


4. REMOVE ENGINE UNDER COVER RH


5. SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY


    A268022
  1. Remove the nut and disconnect the transmission control cable assembly from the control shaft lever.

  1. Using a screwdriver, disengage the 4 claws and disconnect the transmission control cable assembly with clip from the No. 1 transmission control cable bracket.

  1. Remove the clip from the transmission control cable assembly.



6. REMOVE SHIFT LEVER POSITION SENSOR


    C243621
  1. Disconnect the connector from the shift lever position sensor.



    C243622
  1. Remove the nut, washer, and control shaft lever from the manual valve shaft.



    C243623E01
  1. Using a screwdriver, pry the tabs of the lock plate.
    Text in Illustration 
    *1
    Lock Plate



    C243624E01
  1. Remove the lock nut and lock plate from the manual valve shaft.
    Text in Illustration 
    *1
    Lock Nut
    *2
    Lock Plate



    C243625
  1. Remove the 2 bolts and pull out the shift lever position sensor from the manual valve shaft.