HYBRID VEHICLE TRANSAXLE > INSTALLATION |
| 1. INSTALL WITH HEAD STRAIGHT SCREW PLUG |
Coat a new O-ring with ATF and install it to the with head straight screw plug.
Using a 10 mm hexagon socket wrench, install the with head straight screw plug to the hybrid vehicle transaxle assembly.
| 2. INSTALL NO. 1 INVERTER COOLING HOSE ASSEMBLY |
Install the No. 1 inverter cooling hose assembly to the hybrid vehicle transaxle assembly.
| 3. INSTALL WIRE HARNESS CLAMP BRACKET |
Install the 2 wire harness clamp brackets to the hybrid vehicle transaxle assembly with the 3 bolts.
| 4. INSTALL HYBRID TRANSAXLE MASS DAMPER |
Install a new gasket and the hybrid transaxle mass damper.
| 5. INSTALL NO. 3 AUTOMATIC TRANSMISSION CASE COVER |
Install the No. 3 automatic transmission case cover to the hybrid vehicle transaxle assembly with the 2 bolts and a new clip.
| 6. INSTALL AUTOMATIC TRANSMISSION CASE COVER |
Engage the 2 guides and install the automatic transmission case cover.
| 7. INSTALL NO. 3 TRANSMISSION CONTROL CABLE BRACKET |
Install the No. 3 transmission control cable bracket to the hybrid vehicle transaxle assembly with the bolt.
| 8. INSTALL NO. 2 TRANSMISSION CONTROL CABLE BRACKET |
Install the No. 2 transmission control cable bracket to the hybrid vehicle transaxle assembly with the bolt.
| 9. INSTALL NO. 1 TRANSMISSION CONTROL CABLE BRACKET |
Install the No. 1 transmission control cable bracket to the hybrid vehicle transaxle assembly with the 2 bolts.
| 10. INSTALL FRONT ENGINE MOUNTING BRACKET |
Install the front engine mounting bracket to the hybrid vehicle transaxle assembly with the 3 bolts.
| 11. INSTALL HYBRID VEHICLE TRANSAXLE ASSEMBLY |
![]() |
Make sure that the knock pins are installed to the engine.
| *1 | Knock Pin |
Install the hybrid vehicle transaxle assembly to the engine with the 9 bolts.
| Bolt | Bolt Length | Torque |
| A, B | 55 mm (2.17 in.) | 64 N*m (653 kgf*cm, 47 ft.*lbf) |
| C | 65 mm (2.56 in.) | 46 N*m (469 kgf*cm, 34 ft.*lbf) |
| D | 32 mm (1.26 in.) | 44 N*m (449 kgf*cm, 32 ft.*lbf) |
| E | 38 mm (1.50 in.) | 28 N*m (286 kgf*cm, 21 ft.*lbf) |
| 12. INSTALL FRONT FRAME ASSEMBLY |
Install the engine mounting insulator LH with the nut.
Install the engine mounting insulator RH with the nut.
Install the front engine mounting insulator with the bolt.
Fully tighten the 9 temporarily installed nuts of the engine mounting insulators to the specified torque.

| *a | Front Engine Mounting Insulator | *b | Engine Mounting Insulator RH |
| *c | Engine Mounting Insulator LH | - | - |
Install the 4 hole plugs.

| *a | Engine Mounting Insulator RH | *b | Engine Mounting Insulator LH |
| 13. CONNECT WIRE HARNESS |
Connect the 3 clamps and install the motor cable to the hybrid vehicle transaxle assembly with the bolt.
![]() |
Connect the 3 clamps, 4 connectors and install the wire harness to the hybrid vehicle transaxle assembly with the 3 bolts.
| 14. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE |