Home › Drivetrain › AXLE AND DIFFERENTIAL › STEERING KNUCKLE

STEERING KNUCKLE > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure listed below is for the LH side.



1. INSTALL STEERING KNUCKLE


    C167714E03
  1. Using SST and a press, install a new front axle hub bearing to the steering knuckle.

    SST
    09950-60020   (09951-00810)
    09950-70010   (09951-07100)



2. INSTALL FRONT DISC BRAKE DUST COVER
  1. Install the front disc brake dust cover to the steering knuckle with the 4 bolts.

    Torque:
    8.3 N*m{ 85 kgf*cm , 73 in.*lbf }



3. INSTALL FRONT AXLE HUB SUB-ASSEMBLY


    C197764E03
  1. Using SST and a press, install the front axle hub sub-assembly to the steering knuckle.

    SST
    09608-32010  
    09950-60010   (09951-00610)
    09950-70010   (09951-07100)



4. INSTALL FRONT AXLE HUB HOLE SNAP RING
  1. Using snap ring pliers, install a new front axle hub hole snap ring.



5. INSTALL FRONT NO. 1 WHEEL BEARING DUST DEFLECTOR
  1. Set a new front No. 1 wheel bearing dust deflector to the steering knuckle while aligning the cutout for the speed sensor in the front No. 1 wheel bearing dust deflector with the hole of the steering knuckle.



    C166274E01
  1. Using SST and a hammer, install the front No. 1 wheel bearing dust deflector.

    SST
    09316-60011   (09316-00011)
    09608-32010  
    09950-60010   (09951-00500, 09952-06010)
    09950-60020   (09951-00810)



6. INSTALL FRONT LOWER BALL JOINT ASSEMBLY
  1. Secure the front axle assembly in a vise using aluminum plates.

    NOTICE:
    When using a vise, do not overtighten it.

  1. Install the front lower ball joint assembly to the front axle assembly with a new nut.

    Torque:
    123 N*m{ 1254 kgf*cm , 91 ft.*lbf }

    NOTICE:
    Prevent oil from adhering to the threaded and tapered parts.

  1. Install a new cotter pin.

    NOTICE:
    Further tighten the nut up to 60° if the holes for the cotter pin are not aligned.



7. INSTALL FRONT AXLE ASSEMBLY