Home › Vehicle Interior › POWER OUTLETS (INT) › POWER OUTLET SOCKET

POWER OUTLET SOCKET > REMOVAL

for Preparation Click here



1. REMOVE FRONT PANEL GARNISH LH


    B384406
  1. Disengage the 3 clips and 8 guides to remove the front panel garnish LH as shown in the illustration.



2. REMOVE FRONT PANEL GARNISH RH


    B384409
  1. Disengage the 3 clips and 8 guides to remove the front panel garnish RH as shown in the illustration.



3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY


    B430424
  1. Disengage the 2 claws and disconnect the shift hole cover sub-assembly as shown in the illustration.



    B430426
  1. Turn the shift lever knob sub-assembly counterclockwise and remove the shift lever knob sub-assembly.



4. REMOVE REAR CONSOLE UPPER PANEL SUB-ASSEMBLY
  1. Move the shift lever to N.



  1. Disengage the 6 clips as shown in the illustration.


    B430428

  1. Disconnect each connector to remove the rear console upper panel sub-assembly.



5. REMOVE UPPER CONSOLE BOX SUB-ASSEMBLY


    B278005
  1. Remove the 2 screws.



    B277989
  1. Disengage the 4 clips and 2 guides as shown in the illustration.



    B280337
  1. Disengage the clamp.

  1. Disconnect the 2 connectors to remove the upper console box sub-assembly.



6. REMOVE NO. 3 POWER OUTLET SOCKET ASSEMBLY


    B280057
  1. Turn the No. 3 power outlet socket assembly in the direction shown in the illustration to disengage the claw.



    B280058
  1. Using a screwdriver, disengage the claw, and then push in the No. 3 power outlet socket assembly until the protrusion of the No. 3 power outlet socket assembly comes into contact with the No. 2 power outlet socket cover.



    B280059
  1. As shown in the illustration, align the protrusion of the No. 3 power outlet socket assembly and the notch of the No. 2 power outlet socket cover.



    B280060
  1. Using a screwdriver, disengage the claw and remove the No. 3 power outlet socket assembly from the No. 2 power outlet socket cover.



7. REMOVE NO. 2 POWER OUTLET SOCKET COVER


    B280061
  1. Disengage the 2 claws and remove the No. 2 power outlet socket cover.