If the spiral cable sub-assembly is not centered, center it.
If the cable cannot be centered, it is possible that the spiral cable sub-assembly is broken. Replace the spiral cable with sensor sub-assembly with a new one.
While pushing on the interlock indicated in the illustration, rotate the spiral cable sub-assembly counterclockwise slowly by hand until it stops.
Text in Illustration

| Interlock
|
- NOTICE:
- When rotating the spiral cable sub-assembly, make sure to push on the interlock indicated in the illustration to release the interlock mechanism.
- Do not turn the spiral cable sub-assembly using the airbag wire harness.
Rotate the spiral cable sub-assembly clockwise approximately 2.5 turns to the position where the colored part shown in the illustration is visible.
Text in Illustration

| Colored Part
|

| Interlock
|
- HINT:
- The spiral cable sub-assembly will rotate approximately 2.5 turns to both the left and right from the center.