Home
›
Brake
›
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS
›
STEERING ANGLE SENSOR
STEERING ANGLE SENSOR > REMOVAL
for Preparation
Click here
NOTICE:
If the both spiral cable sub-assembly and the steering sensor are malfunctioning, replace them with a new spiral cable with sensor sub-assembly.
1. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
(
Click here
)
2. REMOVE STEERING SENSOR
Disengage the 6 claws and remove the steering sensor from the spiral cable sub-assembly.
NOTICE:
Do not damage the claws and pins of the spiral cable sub-assembly.