Home › Engine / Hybrid System › 2AR-FXE FUEL › FUEL PUMP

FUEL PUMP > REASSEMBLY

for Preparation Click here



1. INSTALL FUEL PUMP


    A192863E04
  1. Apply gasoline to a new O-ring. Then install the O-ring and fuel pump spacer to the fuel pump.
    Text in Illustration 
    *1
    O-ring
    *2
    Fuel Pump Spacer



    A136240E01
  1. Engage the 5 claws on the fuel filter and install the fuel pump with the suction filter.
    Text in Illustration 
    *1
    Fuel Filter
    *2
    Suction Filter

    NOTICE:
    1. Make sure that the O-ring is not cut or pinched during the installation.
    2. Engage the claws securely.
    3. Do not remove the suction filter.

    HINT:
    Perform "Inspection After Repair" after replacing the fuel pump (Click here).



2. INSTALL NO. 1 FUEL SUCTION SUPPORT


    A255955
  1. Engage the 2 claws of the No. 1 fuel suction support.



3. INSTALL LOWER FUEL TANK CASE SUB-ASSEMBLY
  1. Connect the fuel pump harness connector to the fuel pump.

  1. Install the spring to the fuel suction plate shaft and install it to the lower fuel tank case sub-assembly.



    A211201
  1. Engage the 4 claws of the No. 1 fuel suction support and install the lower fuel tank case sub-assembly to the fuel suction plate with the fuel filter.

  1. Install a new E-ring.

  1. Connect the fuel pump harness connectors to the fuel suction plate.



4. INSTALL FUEL SENDER GAUGE ASSEMBLY


    A259313
  1. Slide the fuel sender gauge to fit the claw.

  1. Connect the connector of the fuel sender gauge assembly.