Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › STEERING PAD

STEERING PAD > REMOVAL

for Preparation Click here



1. PRECAUTION

CAUTION:
Be sure to read Precaution thoroughly before servicing (Click here).

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Click here).



2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER


    A259067
  1. Disengage the claw to remove the luggage trim service hole cover.



3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



4. REMOVE LOWER NO. 3 STEERING WHEEL COVER


    B279722
  1. Disengage the claw and guide to remove the lower No. 3 steering wheel cover.



5. REMOVE LOWER NO. 2 STEERING WHEEL COVER


    B279723
  1. Disengage the claw and guide to remove the lower No. 2 steering wheel cover.



6. REMOVE HORN BUTTON ASSEMBLY

CAUTION:
When storing the horn button assembly, keep the airbag deployment side facing upward.

  1. Check that the power switch is off.

  1. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



    B279724E01
  1. Using a screwdriver, push up the torsion spring to disengage the pin.
    Text in Illustration 
    *1
    Torsion Spring

    HINT:
    Insert the screwdriver from the installation hole of the lower No. 3 steering wheel cover.



    B279725E01
  1. Using a screwdriver, push in the 2 torsion springs to disengage the 2 pins.
    Text in Illustration 
    *1
    Torsion Spring

    NOTICE:
    Do not drop the horn button assembly.

    HINT:
    Insert the screwdriver from the installation holes in the lower No. 3 steering wheel cover and lower No. 2 steering wheel cover.

  1. Pull out the horn button assembly from the steering wheel assembly and support the horn button assembly with one hand.

    NOTICE:
    When removing the horn button assembly, do not pull the airbag wire harness.



    B282204E01
  1. Disconnect the horn connector from the horn button assembly.

  1. Using a screwdriver with its tip wrapped with protective tape, release the airbag connector lock.
    Text in Illustration 
    *1
    Protective Tape
    *2
    Airbag Connector
    *3
    Horn Connector
    *4
    Airbag Connector Lock

  1. Disconnect the airbag connector to remove the horn button assembly.

    NOTICE:
    When disconnecting any airbag connector, take care not to damage the airbag wire harness.