Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY

FRONT PASSENGER AIRBAG ASSEMBLY > REMOVAL

for Preparation Click here



1. PRECAUTION

CAUTION:
Be sure to read Precaution thoroughly before servicing.
for Separate Type Yaw Rate Sensor: (Click here)
for Built-in Type Yaw Rate Sensor: (Click here)

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Click here).



2. REMOVE NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY
(Click here)


3. DISCONNECT NO. 2 INSTRUMENT PANEL WIRE
  1. Check that the power switch is off.

  1. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



    B288991E01
  1. Slide the slider to release the lock, and then disconnect the connector.
    Text in Illustration 
    *a
    Slider

    NOTICE:
    When disconnecting any airbag connector, take care not to damage the airbag wire harness.



4. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY


  1. Disconnect each connector.


    B293645

  1. Disengage each clamp.



    B284917
  1. Disconnect the glove box light as shown in the illustration.



  1. Remove the 2 passenger airbag bolts <A>.


    B281789E01


    Text in Illustration 
    *1
    Passenger Airbag Bolt <A>
    *2
    Bolt <B>
    *3
    Nut <E> or <F>
    *4
    Clip

  1. Remove the 3 bolts <B> and nut <E> or <F>.

  1. Remove the 2 clips.



  1. Disengage the 5 guides and remove the instrument panel safety pad assembly as shown in the illustration.


    B281790

    NOTICE:
    1. Do not damage the instrument panel safety pad assembly.
    2. Do not allow the wire harnesses to interfere with the surrounding parts.



5. REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY

CAUTION:
When storing the instrument panel passenger airbag assembly, keep the airbag deployment side facing upward.



    B296281
  1. Remove the 2 screws.



    B296282
  1. Lean the instrument panel safety pad assembly and disengage the 3 hooks.



    B296283
  1. Disengage the 3 hooks to remove the instrument panel passenger airbag assembly from the instrument panel safety pad assembly.



6. REMOVE NO. 2 INSTRUMENT PANEL WIRE


    B296284E01
  1. Disengage the clamp.

  1. Using a screwdriver with the tip wrapped with protective tape, release the airbag connector lock.
    Text in Illustration 
    *1
    Protective Tape
    *2
    Airbag Connector
    *3
    Airbag Connector Lock

  1. Disconnect the airbag connector to remove the No. 2 instrument panel wire from the instrument panel passenger airbag assembly.

    NOTICE:
    When disconnecting any airbag connector, take care not to damage the airbag wire harness.