CURTAIN SHIELD AIRBAG ASSEMBLY > INSTALLATION |
| 1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY |
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Temporarily install the curtain shield airbag assembly with the 2 hooks.

Install 2 new bolts in the order shown in the illustration.
Install the curtain shield airbag assembly to the body panel with 5 claws, 6 new clips and 2 new spacers in the order shown in the illustration.

| *1 | Pin | *2 | Clip |
| *3 | Curtain Shield Airbag Assembly | *4 | Body Panel |
| *5 | Spacer | - | - |
![]() |
Push in a new pin to each clip.
![]() |
Connect the curtain shield airbag connector.
| *1 | Airbag Connector |
| *2 | Airbag Connector Lock |
Push in the lock to install the curtain shield airbag connector.
| 2. INSTALL ROOF HEADLINING ASSEMBLY |
| 3. PERFORM DIAGNOSTIC SYSTEM CHECK |