Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF SYSTEM

SLIDING ROOF SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY)


  1. Disconnect the S4 sliding roof ECU (sliding roof drive gear sub-assembly) connector.


    B270994E01

  2. Measure the resistance and voltage according to the value(s) in the table below.

    HINT:
    Measure the values on the wire harness side with the connector disconnected.


    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    S4-8 (B) - S4-12 (E)
    B - W-B
    Auxiliary battery power supply
    Power switch off
    11 to 14 V
    S4-1 (IG) - S4-12 (E)
    GR - W-B
    IG power supply
    Power switch off
    Below 1 V
    S4-1 (IG) - S4-12 (E)
    GR - W-B
    IG power supply
    Power switch on (IG)
    11 to 14 V
    S4-12 (E) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    If the result is not as specified, there may be a malfunction in the wire harness.

  3. Reconnect the S4 sliding roof ECU (sliding roof drive gear sub-assembly) connector.

  4. Measure the voltage according to the value(s) in the table below.

    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    S4-7 (OPN) - S4-12 (E)
    B - W-B
    Sliding roof motor open
    Power switch on (IG), OPEN switch on
    Below 1 V
    S4-7 (OPN) - S4-12 (E)
    B - W-B
    Sliding roof motor open
    Power switch on (IG), OPEN switch off
    11 to 14 V
    S4-5 (CLS) - S4-12 (E)
    G - W-B
    Sliding roof motor close
    Power switch on (IG), CLOSE switch on
    Below 1 V
    S4-5 (CLS) - S4-12 (E)
    G - W-B
    Sliding roof motor close
    Power switch on (IG), CLOSE switch off
    11 to 14 V
    S4-4 (UP) - S4-12 (E)
    R - W-B
    Sliding roof motor up
    Power switch on (IG), UP switch on
    Below 1 V
    S4-4 (UP) - S4-12 (E)
    R - W-B
    Sliding roof motor up
    Power switch on (IG), UP switch off
    11 to 14 V
    S4-6 (DWN) - S4-12 (E)
    L - W-B
    Sliding roof motor down
    Power switch on (IG), DOWN switch on
    Below 1 V
    S4-6 (DWN) - S4-12 (E)
    L - W-B
    Sliding roof motor down
    Power switch on (IG), DOWN switch off
    11 to 14 V
    If the result is not as specified, the sliding roof ECU (sliding roof drive gear sub-assembly) may have a malfunction.