Home › Vehicle Interior › INTERIOR PANELS / TRIM › REAR SUNSHADE SYSTEM

REAR SUNSHADE SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Connect the GTS to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the GTS on.

  4. Enter the following menus: Powertrain / Hybrid Control / Data List.

  5. Read the Data List according to the display on the GTS.

    Hybrid Control 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Shift Sensor SW - R
    Shift lever position sensor / ON or OFF
    ON: Shift lever in R
    OFF: Shift lever in any position other than R
    -


ACTIVE TEST

HINT:
Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the GTS to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the GTS on.

  4. Enter the following menus: Body Electrical / Main Body / Active Test.

  5. Perform the Active Test according to the display on the GTS.

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Reverse Gear Signal
    Reverse signal
    OFF/ON
    -