Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › BATTERY SMART UNIT

BATTERY SMART UNIT > REMOVAL

for Preparation Click here



1. PRECAUTION
(Click here)


2. REMOVE SERVICE PLUG GRIP
(Click here)


3. SEPARATE REAR SEATBACK ASSEMBLY
  1. Fold down the rear seatback assembly RH.

  1. Disconnect the rear seat outer belt from the rear seat center shoulder belt guide.



    B284995
  1. Using a moulding remover, disengage the claw and guide, and remove the No. 2 room partition cover.



    B284997
  1. Pull the cable in the direction shown in the illustration to release the rear seatback lock and then fold the rear seatback assembly LH forward.



4. REMOVE CONNECTOR COVER ASSEMBLY

CAUTION:
  1. Do not touch the high voltage connectors and terminals for 10 minutes after the service plug grip is removed.
  2. Wear insulated gloves.

NOTICE:
Do not start the hybrid system with the service plug grip removed because it may cause a malfunction.



    A258734
  1. Remove the 2 bolts and connector cover assembly.

    NOTICE:
    1. Make sure to pull the connector cover assembly straight up, as a connector is connected to the bottom of the cover.
    2. Do not allow any foreign objects or water to enter the inverter with converter assembly.



5. CHECK TERMINAL VOLTAGE

CAUTION:
Wear insulated gloves.

NOTICE:
Do not allow any foreign objects or water to enter the inverter with converter assembly.



    A258735
  1. Using a voltmeter, measure the voltage between the terminals of the 2 phase connectors.

    Standard voltage:
    0 V

    HINT:
    Use a measuring range of DC 750 V or more on the voltmeter.



6. INSTALL CONNECTOR COVER ASSEMBLY

CAUTION:
Wear insulated gloves.

NOTICE:
  1. Make sure that the interlock is fully engaged.
  2. Do not allow any foreign objects or water to enter the inverter with converter assembly.

  1. Install the connector cover assembly with the 2 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }



7. REMOVE NO. 1 HV BATTERY LH COVER BRACKET


    A332117E01
  1. Using the service plug grip, remove the battery cover lock striker.
    Text in Illustration 
    *1
    Service Plug Grip
    *2
    Battery Cover Lock Striker
    *a
    Button
    *b
    Turn
    *c
    Projection

    HINT:
    Insert the projection part of the service plug grip, turn the button of the battery cover lock striker counterclockwise, and release the lock.



    A332119
  1. Remove the 2 nuts and No. 1 HV battery LH cover bracket from the HV battery.



8. REMOVE NO. 2 HYBRID VEHICLE BATTERY SHIELD PANEL

CAUTION:
Wear insulated gloves.



    A311338
  1. Disconnect the 2 battery smart unit connectors.

  1. Remove the 2 bolts and No. 2 hybrid vehicle battery shield panel from the HV battery.



    A260008
  1. Disengage the 3 wire harness clamps from the No. 2 hybrid vehicle battery shield panel.



9. REMOVE BATTERY SMART UNIT

CAUTION:
Wear insulated gloves.



    A332120
  1. Disengage the 2 claws to remove the wiring harness protector cover from the battery smart unit connector.



    A332121
  1. Disconnect the battery smart unit connector.

    NOTICE:
    Insulate the removed connector with insulating tape.



    A332122
  1. Remove the wiring harness protector from the battery smart unit connector.



    A259414
  1. Remove the bolt and battery smart unit from the HV battery.