Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY

STEERING COLUMN ASSEMBLY > DISASSEMBLY

for Preparation Click here


NOTICE:
  1. When using a vise, do not overtighten it.
  2. Do not drop the power steering ECU with motor assembly, strike it with tools or subject it to impacts.
  3. If the power steering ECU with motor assembly is subjected to an impact, replace it with a new one.
  4. Do not pull the wire harness of the electric power steering column sub-assembly.
  5. Do not allow any moisture to come into contact with the power steering ECU with motor assembly.
  6. Do not loosen any bolts not mentioned in the procedure.



1. REMOVE STEERING LOCK ACTUATOR ASSEMBLY
  1. Using a center punch, mark the center of the 2 tapered-head bolts.

  1. Using a 3 to 4 mm (0.118 to 0.157 in.) diameter drill bit, drill a hole in each tapered-head bolt.



    C236195
  1. Using a screw extractor, remove each tapered-head bolt, and then remove the steering lock actuator assembly from the steering column assembly.



2. REMOVE POWER STEERING ECU PROTECTOR


    C241687
  1. Disengage the 2 claws to remove the power steering ECU protector from the power steering ECU with motor assembly.



3. REMOVE ECU WIRE SUB-ASSEMBLY


    C236193
  1. Disconnect the 2 connectors from the power steering ECU assembly.

  1. Disengage the 2 wire harness clamps to remove the ECU wire sub-assembly.



4. REMOVE POWER STEERING ECU WITH MOTOR ASSEMBLY


    C236194E01
  1. Secure the steering column assembly in a vice using aluminum plates as shown in the illustration.
    Text in Illustration 
    *1
    Aluminum Plate
    *2
    Wooden Block

    NOTICE:
    1. Do not overtighten the vice, as the steering column assembly may become deformed.
    2. Support the steering column assembly with a wooden block or similar item to ensure that it does not fall.



    C236197
  1. Disconnect the 2 connectors from the power steering ECU with motor assembly.



    C236198
  1. Remove the 2 bolts and power steering ECU with motor assembly from the electric power steering column sub-assembly.



    C239326
  1. Remove the O-ring from the power steering ECU with motor assembly.



5. REMOVE POWER STEERING ECU ASSEMBLY


    C236199
  1. Disengage the 4 claws to remove the protector.



    C239324
  1. Remove the 3 bolts.



    C239325
  1. Remove the 2 bolts to remove the power steering ECU assembly from the power steering motor assembly.