Home › Engine / Hybrid System › 2AR-FXE STARTING › POWER SWITCH

POWER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT PUSH START SWITCH


  1. Measure the resistance according to the value(s) in the table below.


    A260269E01

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    5 (SS1) - 6 (GND)
    Not pushed
    10 kΩ or higher
    1 (SS2) - 6 (GND)
    5 (SS1) - 6 (GND)
    Pushed
    Below 1 Ω
    1 (SS2) - 6 (GND)

    If the result is not as specified, replace the push start switch.



  1. Apply battery voltage between the terminals of the switch, and check the illumination condition of the push start switch.


    A260269E04


    Text in Illustration 
    *a
    Indicator Light

    HINT:
    1. If a positive (+) battery lead and a negative (-) battery lead are incorrectly connected, the push start switch indicator light will not illuminate.
    2. If the voltage is too low, the indicator light will not illuminate.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 9 (SWIL)
    Battery negative (-) → Terminal 6 (GND)
    Illuminates

    If the result is not as specified, replace the push start switch.