REAR SUNSHADE SYSTEM > Rear Sunshade does not Operate with Rear Sunshade Switch |

| 1.INSPECT REAR SUNSHADE SWITCH ASSEMBLY |
![]() |
Remove the rear sunshade switch assembly (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 6 (ECU) - 3 (E2) | Rear sunshade switch pushed | Below 1 Ω |
| 6 (ECU) - 3 (E2) | Rear sunshade switch not pushed | 10 kΩ or higher |
| *a | Component without harness connected (Rear Sunshade Switch Assembly) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (REAR SUNSHADE RELAY (REAR WINDOW SHADE ASSEMBLY) - REAR SUNSHADE SWITCH ASSEMBLY - BODY GROUND) |
Disconnect the N42 rear sunshade relay (rear window shade assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| N42-5 (SW) - I184-6 (ECU) | Always | Below 1 Ω |
| N42-5 (SW) - Body ground | Always | 10 kΩ or higher |
| I184-3 (E2) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (REAR SUNSHADE RELAY (REAR WINDOW SHADE ASSEMBLY) - AUXILIARY BATTERY AND BODY GROUND) |
Disconnect the N42 rear sunshade relay (rear window shade assembly) connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| N42-8 (B) - Body ground | Power switch off | 11 to 14 V |
| N42-7 (IG) - Body ground | Power switch off | Below 1 V |
| N42-7 (IG) - Body ground | Power switch on (IG) | 11 to 14 V |
| Tester Connection | Condition | Specified Condition |
| N42-1 (E) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||