Home › Vehicle Interior › INTERIOR PANELS / TRIM › REAR SUNSHADE SYSTEM

REAR SUNSHADE SYSTEM > Rear Sunshade Shift-linked Function does not Operate when Shift Lever is Moved to R Position

for Preparation Click here


DESCRIPTION

When the power switch is on (IG) and the shift lever is moved to R, the shift lever position sensor sends a reverse (R) signal to the power management control ECU. Then, the power management control ECU sends this signal to the main body ECU (multiplex network body ECU) via CAN. When the rear sunshade relay (rear window shade assembly) receives this signal with the rear sunshade raised, the rear sunshade is lowered.

WIRING DIAGRAM


B235132E21


INSPECTION PROCEDURE

NOTICE:
Since the rear sunshade system has functions that use CAN communication, first confirm that there is no malfunction in the CAN communication system using the How to Proceed with Troubleshooting procedure (Click here).

1.READ VALUE USING GTS
  1. Connect the GTS to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the GTS on.

  1. Enter the following menus: Powertrain / Hybrid Control / Data List.

  1. Read the Data List according to the display on the GTS.

    Hybrid Control 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Shift Sensor SW - R
    Shift lever position sensor / ON or OFF
    ON: Shift lever in R
    OFF: Shift lever in any position other than R
    -

    OK:
    The GTS display changes according to the shift state selected using the shift lever.



NG
GO TO HYBRID CONTROL SYSTEM (Click here)
OK


2.PERFORM ACTIVE TEST USING GTS
  1. Connect the GTS to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the GTS on.

  1. Enter the following menus: Body / Main Body / Active Test.

  1. Perform the Active Test according to the display on the GTS.

    HINT:
    Make sure the rear window shade assembly is raised before performing Active Test.


    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Reverse Gear Signal
    Reverse signal
    OFF/ON
    -

OK:
The rear window shade assembly is lowered.



NG
Go to step 3
OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)  

3.CHECK HARNESS AND CONNECTOR (REVERSE SIGNAL)
  1. Disconnect the N42 rear sunshade relay (rear window shade assembly) connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    N42-3 (REV) - Body ground
    Always
    11 to 14 V



NG
Go to step 4
OK

REPLACE REAR SUNSHADE RELAY (REAR WINDOW SHADE ASSEMBLY) (Click here)  

4.CHECK HARNESS AND CONNECTOR (REAR SUNSHADE RELAY (REAR WINDOW SHADE ASSEMBLY) - MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU))
  1. Disconnect the I13 main body ECU (multiplex network body ECU) connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    N42-3 (REV) - I13-15 (REV)
    Always
    Below 1 Ω
    I13-15 (REV) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)