Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM

DTC    P321F-319    Part of HV Gate Blocking Range/Performance

for Preparation Click here


DESCRIPTION

Refer to the description for DTC P321E-318 .

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P321F
319
  1. An open or ground short in the HV gate block signal circuit when the gate is operating
  2. When the HV gate block function is being checked, inverter voltage (VH) drops or current flows in the inverter. (Either the motor (MG2) or the generator (MG1) is malfunctioning.)
Inverter with converter assembly

INSPECTION PROCEDURE

1.CHECK DTC OUTPUT (HYBRID CONTROL)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the power switch on (IG).

  1. Enter the following menus: Powertrain / Hybrid Control / DTC.

  1. Check if DTCs are output.

    Result:
    Result
    Proceed to
    P321E-318 is not output.
    A
    P321E-318 is also output.
    B

  1. Turn the power switch off.



B
GO TO DTC CHART (P321E-318) (Click here)
A

REPLACE INVERTER WITH CONVERTER ASSEMBLY (Click here)