AIRBAG SYSTEM (for Built-in Type Yaw Rate Sensor) > DATA LIST / ACTIVE TEST |
| DATA LIST FOR AIRBAG SENSOR ASSEMBLY |
Turn the power switch off.
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / SRS Airbag / Data List.
Check the values by referring to the table below.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Display Type Information | Display Type Information/ LR: The display is indicated by LH/RH DP: The display is indicated by Driver/Passenger | LR | - |
| Number of Past DTC | Number of Past DTC/ Min.: 0, Max.: 255 | 0 | - |