Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM

ELECTRONICALLY CONTROLLED BRAKE SYSTEM > CHECK FOR INTERMITTENT PROBLEMS

for Preparation Click here



CHECK FOR INTERMITTENT PROBLEMS

HINT:
A momentary interruption (open circuit) in the connectors and/or wire harnesses between the sensors and ECUs can be detected using the Data List function of the intelligent tester.

  1. Turn the power switch off.

  2. Connect the intelligent tester to the DLC3.

  3. Turn the power switch on (IG).

  4. Turn the intelligent tester on.

  5. Follow the directions on the intelligent tester to display the Data List and select areas where momentary interruptions should be monitored.

    HINT:
    1. A momentary interruption (open circuit) cannot be detected for 3 seconds after the power switch is turned on (IG) (initial check).
    2. If Error remains displayed for one of the items on the intelligent tester, check for continuity between the ECU and the item for which Error is displayed.
    3. If a momentary interruption occurs and Error is displayed on the intelligent tester, Error will remain displayed on the intelligent tester for 1 second after the circuit returns to normal.


    ABS/VSC/TRC 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    FR Speed Open
    Front speed sensor RH open detection / Error or Normal
    Error: Momentary interruption
    Normal: Normal
    -
    FL Speed Open
    Front speed sensor LH open detection / Error or Normal
    Error: Momentary interruption
    Normal: Normal
    -
    RR Speed Open
    Rear speed sensor RH open detection / Error or Normal
    Error: Momentary interruption
    Normal: Normal
    -
    RL Speed Open
    Rear speed sensor LH open detection / Error or Normal
    Error: Momentary interruption
    Normal: Normal
    -
    Yaw Rate Open
    Yaw rate sensor open detection / Error or Normal
    Error: Momentary interruption
    Normal: Normal
    -
    Deceleration Open
    Acceleration sensor open detection / Error or Normal
    Error: Momentary interruption
    Normal: Normal
    -
    Steering Open
    Steering angle sensor open detection / Error or Normal
    Error: Momentary interruption
    Normal: Normal
    -
    Master Cylinder Open
    Regulator pressure sensor open detection / Error or Normal
    Error: Momentary interruption
    Normal: Normal
    -
    Stroke Open
    Brake pedal stroke sensor assembly open detection / Error or Normal
    Error: Momentary interruption
    Normal: Normal
    -
    FR Wheel Cylinder Open
    Wheel cylinder pressure sensor open detection / Error or Normal
    Error: Momentary interruption
    Normal: Normal
    -
    Accumulator Open
    Accumulator pressure sensor open detection / Error or Normal
    Error: Momentary interruption
    Normal: Normal
    -
    HV Communication Open
    Hybrid vehicle communication open detection / Error or Normal
    Error: Momentary interruption
    Normal: Normal
    -

  6. While observing the screen, gently jiggle the connectors or wire harnesses between the ECUs and sensors, or between ECUs.

    OK:
    Normal is displayed.

    HINT:
    If the display changes, this indicates that there has been a momentary interruption (open circuit) in the connector and/or wire harness. In this case, repair or replace the connectors and/or wire harnesses as one of them is faulty.