Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › SMART ENTRY AND START SYSTEM (for Start Function)

SMART ENTRY AND START SYSTEM (for Start Function) > SYSTEM DIAGRAM

for Preparation Click here



B388620E01


B298918E10


Component
Outline
Power switch
  1. Transponder key amplifier
  1. Transmits power switch signal to power management control ECU.
  2. Receives ID code and transmits it to certification ECU (smart key ECU assembly) when transmitter battery is low.
Power management control ECU
  1. Changes the power source mode in 4 stages (off, on (ACC), on (IG), on (READY)) in accordance with the shift state and stop light switch.
  2. Controls the push-button start function in accordance with signals received from switches and ECUs.
  3. Permits the steering lock ECU (steering lock actuator assembly) to supply power to activate the motor. Power management control ECU and certification ECU (smart key ECU assembly) permit starting of hybrid control system after receiving unlock signal from steering lock ECU (steering lock actuator assembly).
Certification ECU (smart key ECU assembly)
  1. Performs key verification.
  2. Controls the electrical key antenna (outside), electrical key antenna (indoor) and door lock/unlock sensor.
  3. Outputs smart entry door lock/unlock commands.
  4. Outputs steering lock actuator assembly lock/unlock command signals.
  5. Outputs immobiliser set/unset commands.
  6. Forms the smart entry detection area.
  7. Receives command signals from the certification ECU (smart key ECU assembly) and outputs immobiliser set and unset command signals to the ECM.
  8. Records codes for smart verification.
Steering lock ECU (steering lock actuator assembly)
  1. Receives command signals from the certification ECU (smart key ECU assembly) and activates the steering lock actuator assembly.
  2. Records codes for smart verification.
Combination meter assembly
  1. Operates various warnings (messages on the multi-information display, sounding of the buzzer in the combination meter), according to the command signals from the certification ECU (smart key ECU assembly).
  2. Displays information when the smart entry and start system has a malfunction.
  3. Outputs a vehicle speed signal to the main body ECU (multiplex network body ECU).
IG, ACC relay
Turns on/off according to the power management control ECU and provides power to each system.
Stop light switch assembly
Detects that the brake pedal has been depressed (switch is on) and outputs a signal to the power management control ECU.
No. 1 indoor electrical key antenna assembly (front floor)
No. 2 indoor electrical key antenna assembly (rear floor)
Sends the request code from the certification ECU (smart key ECU assembly) and forms the vehicle interior detection area.
Door control receiver
Receives the smart entry and start system code/wireless code sent from the electrical key transmitter sub-assembly and sends it to the certification ECU (smart key ECU assembly).
Electrical key transmitter sub-assembly
Sends the ID code upon receiving a request signal.