DTC P0A0F-238 Engine Failed to Start |
| DTC No. | INF Code | DTC Detection Condition | Trouble Area |
| P0A0F | 238 | Engine does not start even though it is being cranked (transaxle input malfunction [engine system]) |
|

| 1.CHECK DTC OUTPUT (HYBRID CONTROL) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Powertrain / Hybrid Control / DTC.
Check if DTCs are output.
| Result | Proceed to |
| P0A0F-238 only is output. | A |
| P0A1D (Hybrid Powertrain Control Module) is output. | B |
Turn the power switch off.
|
| ||||
| A | |
| 2.CHECK CRANKSHAFT PULLEY REVOLUTION (P POSITION) |
Check that the shift lever is in the P position.
Lift up the vehicle.
Turn the crankshaft pulley using hand tools to check if the crankshaft can rotate smoothly.
Lower the vehicle.
|
| ||||
| OK | |
| 3.CLEAR DTC |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Powertrain / Hybrid Control / DTC.
Read and record the DTCs and freeze frame data.
Clear DTCs and freeze frame data.
Turn the power switch off.
| NEXT | |
| 4.CHECK ENGINE RACING |
Connect the intelligent tester to the DLC3.
Turn the power switch on (READY).
Enter the following menus: Powertrain / Hybrid Control / Data List / Generator (MG1) Rev, Engine Revolution.
Read the Data List.
![]() |
While the READY indicator is on, fully depress the accelerator pedal for 10 seconds.
| Data List | ENGINE REV | MG1 REV |
| Reference Value | Approximately 1000 rpm | Approximately 3600 rpm |
| Approximately 1500 rpm | Approximately 5400 rpm | |
| Approximately 2500 rpm | Approximately 9000 rpm |
Turn the power switch off.
|
| ||||
| OK | |
| 5.CHECK CREEP MOVEMENT |
Turn the power switch on (READY).
Depress the brake pedal, move the shift lever to D, and release the brake pedal.
Turn the power switch off.
|
| ||||
| OK | |
| 6.INSPECT ENGINE SPEED |
Connect the intelligent tester to the DLC3.
Turn the power switch on (READY).
Enter the following menus: Powertrain / Hybrid Control / Data List / Motor (MG2) Revolution, Generator (MG1) Rev, Engine Revolution.
Read the Data List.
Move the shift lever to D.
Fully depress the accelerator pedal to accelerate the vehicle from a stop.
Turn the power switch off.
|
| ||||
| OK | ||
| ||
| 7.CHECK CRANKSHAFT PULLEY REVOLUTION (N POSITION) |
Lift up the vehicle.
Move the shift lever to N.
Turn the crankshaft pulley using hand tools to check if the crankshaft can rotate smoothly.
Lower the vehicle.
|
| ||||
| OK | ||
| ||