DTC P324E-788 MG-ECU Power Relay Intermittent Circuit |
| DTC No. | INF Code | DTC Detection Condition | Trouble Area |
| P324E | 788 | Error in reset signal from the inverter assembly power source IC |
|

| 1.CHECK DTC OUTPUT (HYBRID CONTROL) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Powertrain / Hybrid Control / DTC.
Check if DTCs are output.
| Result | Proceed to |
| P324E-788 only is output. | A |
| U0110-159, 160, 656, 657 are also output. | B |
Turn the power switch off.
|
| ||||
| A | |
| 2.CHECK CONNECTOR CONNECTION CONDITION (INVERTER WITH CONVERTER ASSEMBLY CONNECTOR) |
Check that the service plug grip is not installed.
Check the connector connections and contact pressure of the low voltage connectors of the inverter with converter assembly (Click here).

|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (INVERTER WITH CONVERTER ASSEMBLY - IGCT RELAY) |
Check that the service plug grip is not installed.
Disconnect connector A14 from the inverter with converter assembly.
Remove the IGCT relay from the No. 2 engine room relay block.
Measure the resistance according to the value(s) in the table below.

| *1 | No. 2 Engine Room Relay Block | *2 | IGCT Relay |
| *a | Front view of wire harness connector (to Inverter with Converter Assembly) | - | - |
| Tester Connection | Switch Condition | Specified Condition |
| A14-30 (+B) - 5 (IGCT relay) | Power switch off | Below 1 Ω |
| A14-31 (+B2) - 5 (IGCT relay) | Power switch off | Below 1 Ω |
| A14-10 (GND1) - Body ground | Power switch off | Below 1 Ω |
| A14-11 (GND2) - Body ground | Power switch off | Below 1 Ω |
Install the IGCT relay.
Connect the power management control ECU connector.
|
| ||||
| OK | ||
| ||