DTC P0BEA-290 Drive Motor "A" Phase V Current Sensor Circuit Range / Performance |
DTC P0BEE-298 Drive Motor "A" Phase W Current Sensor Circuit Range / Performance |
DTC P1C3C-294 Drive Motor "A" Phase V Current Sensor Correlation |
DTC P1C3D-302 Drive Motor "A" Phase W Current Sensor Correlation |
DTC P1C4A-288 Drive Motor "A" Phase V Current Sensor Sub Circuit Range / Performance |
DTC P1C4F-296 Drive Motor "A" Phase W Current Sensor Sub Circuit Range / Performance |
DTC P1C6D-501 Drive Motor "A" Phase V Current Sensor Offset Range / Performance |
DTC P1C6E-502 Drive Motor "A" Phase W Current Sensor Offset Range / Performance |
| DTC No. | INF Code | DTC Detection Condition | Trouble Area |
| P0BEA | 290 | Malfunction in motor inverter current sensor (phase V main sensor)* (1 trip detection logic) | Inverter with converter assembly |
| P0BEE | 298 | Malfunction in motor inverter current sensor (phase W main sensor)* (1 trip detection logic) | |
| P1C3C | 294 | Malfunction in motor inverter current sensor (performance problem or open of phase V sensors)* Detects an abnormal condition when the difference between the output of the phase V main sensor and phase V sub sensor is larger than the standard. (1 trip detection logic) | |
| P1C3D | 302 | Malfunction in motor inverter current sensor (performance problem or open of phase W sensors)* Detects an abnormal condition when the difference between the output of the phase W main sensor and phase W sub sensor is larger than the standard. (1 trip detection logic) | |
| P1C4A | 288 | Malfunction in motor inverter current sensor (phase V sub sensor)* (1 trip detection logic) | |
| P1C4F | 296 | Malfunction in motor inverter current sensor (phase W sub sensor)* (1 trip detection logic) | |
| P1C6D | 501 | Malfunction in motor inverter current sensor (phase V main and sub sensors offset)* (1 trip detection logic) | |
| P1C6E | 502 | Malfunction in motor inverter current sensor (phase W main and sub sensors offset)* (1 trip detection logic) |
| 1.CHECK DTC OUTPUT (HYBRID CONTROL) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Powertrain / Hybrid Control / DTC.
Check if DTCs are output.
| Result | Proceed to |
| P0BEA-290, P0BEE-298, P1C3C-294, P1C3D-302, P1C4A-288, P1C4F-296, P1C6D-501 or P1C6E- 502 only is output. | A |
| P0A78-202 is output. | B |
Turn the power switch off.
|
| ||||
| A | |
| 2.CHECK CONNECTOR CONNECTION CONDITION (INVERTER WITH CONVERTER ASSEMBLY CONNECTOR) |
Check that the service plug grip is not installed.
Check the connector connections and contact pressure of the low voltage connectors of the inverter with converter assembly (Click here).

|
| ||||
| OK | ||
| ||