DTC B2286 Runnable Signal Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area | DTC Output Confirmation Operation |
| B2286 | READY signal error inside the power management control ECU (1-trip detection logic*) |
| Turn the power switch on (IG) and wait 20 seconds or more. |
| Vehicle Condition when Malfunction Detected | Fail-safe Function when Malfunction Detected |
| The power source mode does not change to on (READY). | - |

| DTC | Data List Item | Active Test Item |
| B2286 | Power Source Control
| - |
| 1.CHECK HARNESS AND CONNECTOR (POWER SOURCE) |
![]() |
Disconnect the I3 and I4 connectors from the power management control ECU.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I3-1 (AM22) - Body ground | Power switch off | 11 to 14 V |
| I4-7 (AM21) - Body ground | Power switch off | 11 to 14 V |
| *a | Front view of wire harness connector (to Power Management Control ECU) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I3-5 (E01) - Body ground | Always | Below 1 Ω |
| I3-6 (E1) - Body ground | Always | Below 1 Ω |
| I4-4 (E12) - Body ground | Always | Below 1 Ω |
| I4-5 (E02) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Power Management Control ECU) |
|
| ||||
| OK | |
| 3.CHECK FOR DTC |
Clear the DTCs (Click here).
Turn the power switch on (IG).
After 25 seconds have elapsed, check if the DTC has been output again.
|
| ||||
| OK | ||
| ||