Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY

FRONT SEAT ASSEMBLY > REMOVAL

for Preparation Click here



1. PRECAUTION

CAUTION:
  1. Be sure to read precaution thoroughly before servicing (Click here).
  2. If the side airbag has deployed, replace the front seat airbag assembly, separate type front seatback spring assembly, separate type front seatback pad and separate type front seatback cover with the necessary parts in accordance with the extent of the collision damage.

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Click here).



2. REMOVE FRONT SEAT HEADREST ASSEMBLY


3. REMOVE FRONT OUTER SEAT TRACK BRACKET COVER
  1. Operate the slide and vertical power seat switch knob and move the seat to the rearmost position.



    B281485
  1. Disengage the 2 claws to remove the front outer seat track bracket cover.



4. REMOVE FRONT INNER SEAT TRACK BRACKET COVER


    B281483
  1. Disengage the 2 claws to remove the front inner seat track bracket cover.



5. REMOVE REAR OUTER SEAT TRACK BRACKET COVER
  1. Operate the slide and vertical power seat switch knob and move the seat to the foremost position.



    B280204
  1. Disengage the 2 claws to remove the rear outer seat track bracket cover.



6. REMOVE REAR INNER SEAT TRACK BRACKET COVER


    B280203
  1. Disengage the 2 claws to remove the rear inner seat track bracket cover.



7. REMOVE FRONT SEAT ASSEMBLY


    B281091
  1. Remove the 2 bolts on the rear side of the seat.

  1. Operate the slide and vertical power seat switch knob and move the seat to the rearmost position.

  1. Remove the 2 bolts on the front side of the seat.

  1. Operate the slide and vertical power seat switch knob and move the seat to the center position. Then, operate the reclining power seat switch knob and move the seatback to the upright position.

  1. Disconnect the cable from the negative (-) auxiliary battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

  1. Disconnect each connector and clamp under the seat.

  1. Remove the front seat assembly.

    NOTICE:
    Be careful not to damage the vehicle body.