Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE PEDAL STROKE SENSOR (for RHD)

BRAKE PEDAL STROKE SENSOR (for RHD) > REMOVAL

for Preparation Click here


NOTICE:
While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch is turned on. Therefore, when servicing brake system components, do not operate the brake pedal or open/close the doors while the auxiliary battery is connected.



1. PRECAUTION

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
(Click here)


3. REMOVE BRAKE PEDAL STROKE SENSOR ASSEMBLY


    C242724
  1. Disconnect the connector from the brake pedal stroke sensor assembly.



    C242725
  1. Remove the 2 bolts and brake pedal stroke sensor assembly from the brake pedal support assembly.

    NOTICE:
    1. Do not drop the brake pedal stroke sensor assembly.
    2. If the brake pedal stroke sensor assembly has been dropped, replace the brake pedal stroke sensor assembly with a new one.