Home › Suspension › FRONT SUSPENSION › FRONT SHOCK ABSORBER

FRONT SHOCK ABSORBER > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure listed below is for the LH side.



1. REMOVE FRONT WHEEL


2. LOOSEN FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT


    C238965
  1. Loosen the front support to front shock absorber nut.

    NOTICE:
    1. Do not remove the front support to front shock absorber nut.
    2. Loosen the front support to front shock absorber nut only when the front shock absorber with coil spring needs to be disassembled.



3. SEPARATE FRONT SPEED SENSOR


    C246176
  1. Remove the bolt and clamp, and separate the front speed sensor and front flexible hose from the front shock absorber assembly.

    NOTICE:
    Be sure to separate the front speed sensor from the front shock absorber assembly completely.



4. SEPARATE FRONT STABILIZER LINK ASSEMBLY


    C238963
  1. Remove the nut and separate the front stabilizer link assembly from the front shock absorber assembly.
    If the ball joint turns together with the nut, use a wrench to hold the stud bolt.



5. REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING


    C238983E01
  1. Support the front axle using a jack and wooden block.
    Text in Illustration 
    *1
    Jack
    *2
    Wooden Block
    V100135
    Front of the Vehicle



    C246177
  1. Remove the 2 bolts and 2 nuts, and separate the front shock absorber with coil spring (lower side) from the steering knuckle.

    NOTICE:
    When removing the nuts, keep the bolts from rotating.



    C238964
  1. Remove the 3 nuts and front shock absorber with coil spring.

    NOTICE:
    Make sure that the front speed sensor is completely separated from the front shock absorber with coil spring.



6. REMOVE FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT


    C267414E01
  1. Secure SST in a vise.

    SST
    09727-30021   (09727-00010, 09727-00021, 09727-00031)



    C275706E01
  1. Attach the arm of SST to the diameter of the front coil spring.
    Text in Illustration 
    *a
    Correct
    *b
    Incorrect

    CAUTION:
    1. Make sure that the front coil spring is installed so that the distance between the upper and lower hooks of SST is at the maximum.
    2. Make sure that the claws of the hooks are securely attached.

  1. Using SST, compress the front coil spring.

    CAUTION:
    1. If the front coil spring bends during the compression, immediately stop the compression and reinstall SST.
    2. Do not compress the spring until the coil springs contact each other.
    3. Do not use an impact wrench. It will damage SST.



    C267415
  1. Confirm that the front coil spring becomes free and remove the front support to front shock absorber nut.

    CAUTION:
    Do not remove the front support to front shock absorber nut when the front coil spring is not free.



7. REMOVE FRONT SUSPENSION SUPPORT SUB-ASSEMBLY


8. REMOVE FRONT SUSPENSION SUPPORT BEARING


9. REMOVE FRONT UPPER COIL SPRING SEAT


10. REMOVE FRONT UPPER COIL SPRING INSULATOR


11. REMOVE FRONT COIL SPRING


12. REMOVE FRONT SPRING BUMPER


13. REMOVE FRONT LOWER COIL SPRING INSULATOR


14. REMOVE FRONT SHOCK ABSORBER ASSEMBLY