Home › Suspension › FRONT SUSPENSION › FRONT STABILIZER BAR

FRONT STABILIZER BAR > INSTALLATION

for Preparation Click here



1. INSTALL FRONT NO. 1 STABILIZER BAR BUSHING


    C239295E01
  1. Install the 2 front No. 1 stabilizer bar bushings to the front stabilizer bar as shown in the illustration.
    Text in Illustration 
    *a
    Cutout
    V100135
    Front of the Vehicle
    V100136
    Inside of the Vehicle

    NOTICE:
    When installing the front No. 1 stabilizer bar bushings, make sure that the cutout faces the rear of the vehicle.



2. INSTALL FRONT STABILIZER BAR
  1. Install the front stabilizer bar to the front frame assembly.



3. INSTALL FRONT NO. 1 STABILIZER BRACKET LH
  1. Install the front No. 1 stabilizer bracket LH to the front frame assembly with the 2 bolts.

    Torque:
    27 N*m{ 275 kgf*cm , 20 ft.*lbf }



4. INSTALL FRONT NO. 1 STABILIZER BRACKET RH

HINT:
Perform the same procedure as the LH side.



5. INSTALL FRONT STABILIZER LINK ASSEMBLY LH
  1. Install the front stabilizer link assembly LH to the front stabilizer bar with the nut.

    Torque:
    74 N*m{ 755 kgf*cm , 55 ft.*lbf }

    If the ball joint turns together with the nut, use a wrench to hold the stud bolt.



6. INSTALL FRONT STABILIZER LINK ASSEMBLY RH

HINT:
Perform the same procedure as the LH side.



7. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE