REAR SHOCK ABSORBER > REMOVAL |
| 1. REMOVE REAR SIDE SEATBACK ASSEMBLY |
| 2. REMOVE REAR WHEEL |
| 3. SEPARATE REAR STABILIZER LINK ASSEMBLY |
![]() |
Remove the nut and separate the rear stabilizer link assembly from the rear shock absorber assembly.
If the ball joint turns together with the nut, use a hexagon wrench to hold the stud.
| 4. SEPARATE SKID CONTROL SENSOR WIRE |
![]() |
Remove the 2 bolts, and disconnect the rear flexible hose and skid control sensor wire from the rear shock absorber assembly.
| 5. REMOVE REAR NO. 1 SUSPENSION SUPPORT COVER |
![]() |
Using a screwdriver, disengage the 4 claws and remove the rear No. 1 suspension support cover.
| 6. REMOVE REAR SHOCK ABSORBER WITH COIL SPRING |
![]() |
Support the rear axle carrier sub-assembly with a jack using a wooden block.
| *1 | Jack |
| *2 | Wooden Block |
![]() |
Loosen the rear support to rear shock absorber nut of the rear shock absorber assembly.
![]() |
Remove the 2 bolts and 2 nuts, and separate the rear shock absorber with coil spring from the rear axle carrier sub-assembly.
![]() |
Remove the 3 nuts and rear shock absorber with coil spring.
| 7. REMOVE REAR SUPPORT TO REAR SHOCK ABSORBER NUT |
![]() |
Secure SST in a vise.
![]() |
Attach the arm of SST to the diameter of the rear coil spring.
| *a | Correct |
| *b | Incorrect |
Using SST, compress the rear coil spring.
Confirm that the rear coil spring becomes free and remove the rear support to rear shock absorber nut.
| 8. REMOVE REAR SUPPORT TO REAR SHOCK ABSORBER COLLAR |
| 9. REMOVE REAR SUSPENSION SUPPORT ASSEMBLY |
| 10. REMOVE REAR COIL SPRING |
| 11. REMOVE REAR NO. 1 SPRING BUMPER |
| 12. REMOVE REAR LOWER COIL SPRING INSULATOR |
| 13. REMOVE REAR SHOCK ABSORBER ASSEMBLY |