REAR STRUT ROD > REMOVAL |
| 1. REMOVE REAR WHEEL |
| 2. REMOVE NO. 2 FLOOR UNDER COVER (for LH Side) |
![]() |
Remove the screw and 2 clips.
![]() | Nut (attached to under cover) |
![]() | Screw |
Disengage the 6 nuts and remove the No. 2 floor under cover.
| 3. REMOVE NO. 1 FLOOR UNDER COVER (for RH Side) |
![]() |
Remove the screw.
![]() | Nut (attached to under cover) |
![]() | Screw |
Disengage the 5 nuts and 2 clips, and remove the No. 1 floor under cover.
| 4. SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY |
![]() |
Remove the bolt and separate the No. 3 parking brake cable assembly from the vehicle.
| 5. REMOVE REAR STRUT ROD ASSEMBLY |
![]() |
Support the rear axle carrier sub-assembly with a jack using a wooden block.
| *1 | Jack |
| *2 | Wooden Block |
![]() |
Remove the bolt and nut, and separate the rear strut rod assembly (front side).
![]() |
Remove the bolt, nut and rear strut rod assembly from the rear axle carrier sub-assembly.