Home › Suspension › REAR SUSPENSION › REAR STABILIZER BAR

REAR STABILIZER BAR > REMOVAL

for Preparation Click here



1. REMOVE REAR WHEELS


2. REMOVE NO. 2 FLOOR UNDER COVER


    C240547
  1. Remove the 2 clips.
    Text in Illustration 
    V100135
    Nut (attached to under cover)

  1. Disengage the 6 nuts and remove the No. 2 floor under cover.

    HINT:
    The 6 nuts will remain attached to the No. 2 floor under cover.



3. REMOVE NO. 1 FLOOR UNDER COVER


    C240546
  1. Disengage the 5 nuts and 2 clips, and remove the No. 1 floor under cover.
    Text in Illustration 
    V100135
    Nut (attached to under cover)

    HINT:
    Rotate the clips to disengage them. The 5 nuts and 2 clips will remain attached to the No. 1 floor under cover.



4. REMOVE REAR STABILIZER LINK ASSEMBLY LH


    C239069
  1. Remove the nut and separate the rear stabilizer link assembly LH from the rear shock absorber assembly.
    If the ball joint turns together with the nut, use a hexagon wrench to hold the stud.



    C241264
  1. Remove the nut and rear stabilizer link assembly LH from the rear stabilizer bar.
    If the ball joint turns together with the nut, use a hexagon wrench to hold the stud.



5. REMOVE REAR STABILIZER LINK ASSEMBLY RH

HINT:
Perform the same procedure as for the LH side.



6. REMOVE REAR STABILIZER BAR


    C240548
  1. Remove the 4 bolts, rear stabilizer bar, 2 rear No. 1 stabilizer bar brackets and 2 rear stabilizer bushings.



7. REMOVE REAR NO. 1 STABILIZER BAR BRACKET
  1. Remove the 2 rear No. 1 stabilizer bar brackets from the rear stabilizer bar.



8. REMOVE REAR STABILIZER BUSHING
  1. Remove the 2 rear stabilizer bushings from the rear stabilizer bar.