Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM

LIGHTING SYSTEM > ACC Signal Circuit

for Preparation Click here


DESCRIPTION

This circuit detects the power switch on (ACC) or off condition, and sends it to the main body ECU (multiplex network body ECU).

WIRING DIAGRAM


E230102E07


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.READ VALUE USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Main Body / Data List.

  1. Read the display on the intelligent tester.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    ACC SW
    Power switch on (ACC) signal/ON or OFF
    ON: Power switch on (ACC)
    OFF: Power switch off
    -

    OK:
    Normal conditions listed above are displayed.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY - AUXILIARY BATTERY AND BODY GROUND)
  1. Disconnect the 3F*1, 3E*2 and 3B instrument panel junction block assembly connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    3F-1 - Body ground*1
    Power switch off
    11 to 14 V
    3E-1 - Body ground*2
    Power switch off
    11 to 14 V
    3B-23 - Body ground
    Power switch on (ACC)
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3B-7 - Body ground
    Always
    Below 1 Ω

    1. *1: for RHD
    2. *2: for LHD



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (ACC NO. 1 RELAY)
  1. Remove the instrument panel junction block assembly (Click here).

  1. Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly.



  1. Measure the resistance according to the value(s) in the table below.


    E191508E07


    Text in Illustration 
    *a
    Component without harness connected
    (Instrument panel junction block assembly)
    -
    -
    *A
    for RHD
    *B
    for LHD

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3F-1 - MB-29 (ACC)*1
    Always
    10 kΩ or higher
    3F-1 - MB-29 (ACC)*1
    Auxiliary battery positive (+) → 3B-23
    Auxiliary battery negative (-) → 3B-7
    Below 1 Ω
    3E-1 - MB-29 (ACC)*2
    Always
    10 kΩ or higher
    3E-1 - MB-29 (ACC)*2
    Auxiliary battery positive (+) → 3B-23
    Auxiliary battery negative (-) → 3B-7
    Below 1 Ω

    1. *1: for RHD
    2. *2: for LHD



NG
REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (Click here)
OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)