FRONT SEAT OUTER BELT ASSEMBLY > INSTALLATION |
| 1. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY |
![]() |
Engage the guide.
Install the bolt <A> first, then the bolt <B> to temporarily install the front shoulder belt anchor adjuster assembly.
Fully tighten the 2 bolts.
| 2. INSPECT FRONT SEAT OUTER BELT ASSEMBLY |
![]() |
Before installing the front seat outer belt assembly, check the ELR function.
When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks.
| *1 | Retractor |
| *a | Unlocked |
| *b | Locked |
| *c | 45° |
| 3. INSTALL FRONT SEAT OUTER BELT ASSEMBLY |
![]() |
Install the bolt <A> first, then the bolt <B> to temporarily install the front seat outer belt assembly.
Fully tighten the 2 bolts.
![]() |
Connect the pretensioner connector and lock the locking button as shown in the illustration.
Connect the shoulder anchor of the front seat outer belt assembly with the nut.
| 4. INSTALL CENTER PILLAR UPPER GARNISH |
Pass the floor anchor of the front seat outer seat belt assembly LH through the center pillar upper garnish LH.
Engage the clip.
Install the center pillar upper garnish LH with the 2 screws.
| 5. INSTALL CENTER PILLAR LOWER GARNISH |
Engage the 2 claws and 3 clips to install the center pillar lower garnish LH.
| 6. CONNECT FRONT SEAT OUTER BELT ASSEMBLY |
Install the floor anchor of the front seat outer belt assembly with the bolt.
Check if the ELR locks.
With the belt assembly installed, check that the belt locks when it is pulled out quickly.
| 7. INSTALL LAP BELT OUTER ANCHOR COVER |
Engage the 3 claws to install the lap belt outer anchor cover.
| 8. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP |
| 9. INSTALL REAR DOOR SCUFF PLATE |
Engage the 6 claws to install the rear door scuff plate LH.
| 10. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP |
| 11. INSTALL FRONT DOOR SCUFF PLATE |
Engage the 10 claws to install the front door scuff plate LH.
| 12. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL |
| 13. INSTALL LUGGAGE TRIM SERVICE HOLE COVER |
Engage the claw to connect the luggage trim service hole cover.
| 14. INSPECT SRS WARNING LIGHT |