REAR VIEW MONITOR SYSTEM > TERMINALS OF ECU |
| REAR TELEVISION CAMERA ASSEMBLY |
Disconnect the T6 connector from the rear television camera assembly.

Measure the voltage of each terminal of the wire harness side connector.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
| T6-6 (CB+) - Body ground | B - Body ground | Power source | Power switch on (IG) Shift lever in R | 5.5 to 7.05 V |
Reconnect the T6 connector to the rear television camera assembly.
Check for pulses between each terminal of the connector.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
| T6-3 (CV+) - T6-2 (CV-) | W - R | Video signal | Power switch on (IG) Shift lever in R Camera lens not covered, displaying an image | Pulse generation (See waveform 1) |
| Power switch on (IG) Shift lever in R Camera lens covered, blacking out screen | Pulse generation (See waveform 2) |
![]() |
Reference (Oscilloscope waveform):
Waveform 1 (camera lens is not covered, displaying an image)
| Item | Content |
| Terminal No. (Symbol) | T6-3 (CV+) - T6-2 (CV-) |
| Tool Setting | 200 mV/DIV., 50 μsec./DIV. |
| Condition | Power switch on (IG), shift lever in R |
Waveform 2 (camera lens is covered, blacking out the screen)
| Item | Content |
| Terminal No. (Symbol) | T6-3 (CV+) - T6-2 (CV-) |
| Tool Setting | 200 mV/DIV., 50 μsec./DIV. |
| Condition | Power switch on (IG), shift lever in R |
| *a | Waveform 1 (camera lens not covered, displaying an image) |
| *b | Waveform 2 (camera lens covered, blacking out the screen) |
| *c | Synchronization Signal |
| *d | Video Waveform |
| RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here) |