Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM

SEAT BELT WARNING SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY


  1. Disconnect the main body ECU (multiplex network body ECU) connectors.


    B282096E20


    Text in Illustration 
    *A
    for LHD
    *B
    for RHD

  2. Measure the resistance and voltage according to the value(s) in the table below.

    HINT:
    Measure the values on the wire harness side with the connector disconnected.


    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    MB-30 (BECU) - Body ground
    -
    Auxiliary battery power supply
    Power switch off
    11 to 14 V
    MB-31 (ALTB) - Body ground
    -
    Auxiliary battery power supply
    Power switch off
    11 to 14 V
    MB-32 (IG) - Body ground
    -
    Ignition power supply (IG signal)
    Power switch on (IG) → off
    11 to 14 V → Below 1 V
    MB-29 (ACC) - Body ground
    -
    Ignition power supply (ACC signal)
    Power switch on (ACC) → off
    11 to 14 V → Below 1 V
    MB-11 (GND1) - Body ground
    -
    Ground
    Always
    Below 1 Ω
    I12-3 (GND2) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    MB-18 (DBKL) - Body ground
    -
    Driver seat belt buckle switch signal
    Driver seat belt fastened
    10 kΩ or higher
    MB-18 (DBKL) - Body ground
    -
    Driver seat belt buckle switch signal
    Driver seat belt unfastened
    Below 1 Ω
    If the result is not as specified, there may be a malfunction in the wire harness.


CHECK COMBINATION METER ASSEMBLY


  1. Disconnect the I18 combination meter assembly connector.


    E224288E01

  2. Measure the resistance according to the value(s) in the table below.

    HINT:
    Measure the values on the wire harness side with the connector disconnected.


    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    I18-20 (ES) - Body ground
    BR - Body ground
    Ground
    Always
    Below 1 Ω
    If the result is not as specified, there may be a malfunction in the wire harness.

  3. Reconnect the I18 combination meter assembly connector.

  4. Measure the voltage according to the value(s) in the table below.

    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    I18-1 (B) - Body ground
    W - Body ground
    Auxiliary battery power supply
    Power switch off
    11 to 14 V
    I18-13 (IG+) - Body ground
    L - Body ground
    Ignition power supply
    (IG signal)
    Power switch off
    Below 1 V
    I18-13 (IG+) - Body ground
    L - Body ground
    Ignition power supply
    (IG signal)
    Power switch on (IG)
    11 to 14 V
    If the result is not as specified, the combination meter assembly may have a malfunction.