Home › Drivetrain › P314 HYBRID TRANSMISSION / TRANSAXLE › HYBRID TRANSAXLE SYSTEM

HYBRID TRANSAXLE SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT FLUID PRESSURE OF OIL PUMP

NOTICE:
Do the test at normal operating fluid temperature 50 to 80°C (122 to 176°F).

  1. Remove the front fender apron seal LH.



    C245074
  1. Remove the fluid pump cover plug and O-ring from the hybrid vehicle transaxle assembly.



    C245073E01
  1. Install the SST to the hybrid vehicle transaxle assembly.

    SST
    09992-00095   (09992-00112, 09992-00271)

  1. Put the engine in inspection mode (Click here).

  1. Measure the fluid pressure.

    Standard:
    Engine Speed
    Transaxle Fluid Pressure
    900 rpm
    9.8 kPa (0.1 kgf/cm2, 1.4 psi) or more

    NOTICE:
    Be sure to cancel the inspection mode immediately after the transaxle fluid pressure check is completed.

  1. Remove the SST from the hybrid vehicle transaxle assembly.

  1. Install a new O-ring and fluid pump cover plug to the hybrid vehicle transaxle assembly.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Install the front fender apron seal LH.