Home › Engine / Hybrid System › 2AR-FXE FUEL › FUEL SENDER GAUGE ASSEMBLY

FUEL SENDER GAUGE ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT FUEL SENDER GAUGE ASSEMBLY


    A259312E01
  1. Check that the float moves smoothly between F and E.
    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Fuel Sender Gauge Assembly)

  1. Measure the resistance between the terminals 1 and 2 of connector according to the value(s) in the table below.

    Standard Resistance:
    Float Level
    Resistance (Ω)
    F
    13.5 to 16.5
    Between E and F
    13.5 to 414.5 (Gradually changes)
    E
    405.5 to 414.5

    If the value is not as specified, replace the fuel sender gauge assembly.