Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT COMBINATION METER ASSEMBLY
  1. INSPECT SPEEDOMETER

    NOTICE:
    1. The meter ECU receives the vehicle speed signal from the skid control ECU via CAN communication. Therefore, perform the following inspection referring to values on the Data List of the skid control ECU because it is the source of the vehicle speed signal.
    2. The Data List values of the skid control ECU are used for this inspection. Therefore, make sure to perform the inspection after confirming that no DTCs are output from the brake control system.
    3. If the tire size or tire inflation pressure is not within the specified range, or the tires are excessively worn, the speedometer indication error will increase. Therefore, make sure to perform the inspection after checking that the tire size, tire inflation pressure and tire wear are in the specified range.


    1. Before starting the following inspection, check if brake control system DTCs are output.

    2. Check the values by referring to the table below.

      ABS/VSC/TRC 
      Tester Display
      Measurement Item/Range
      Normal Condition
      Diagnostic Note
      Vehicle Speed
      Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
      Vehicle stopped: 0 km/h (0 mph)
      When driving at constant speed: No large fluctuations

      Reference: km/h 
      Intelligent Tester Indication (km/h)
      Acceptable Range (km/h)
      20
      21.0 to 25.0
      40
      41.7 to 46.2
      60
      62.7 to 67.2
      80
      83.4 to 88.4
      100
      104.3 to 109.3
      120
      125.1 to 130.6
      140
      145.8 to 151.8
      160
      166.2 to 173.2
      180
      186.9 to 194.5
      200
      207.7 to 215.7
      220
      228.4 to 236.8

  1. CHECK LED ILLUMINATION (BULB CHECK)

    1. Check the illumination function of the warning or indicator lights listed below when turning the power switch on (IG).

      OK:

      Warning or Indicator Light
      Specified Condition
      Leveling
      Warning or indicator light comes on for about 3 seconds after turning the power switch on (IG).
      Master
      SRS
      Warning light comes on for about 6 seconds after turning the power switch on (IG).
      Oil pressure
      Indicator or warning light comes on when turning the power switch on (IG).
      Charge
      EPS
      MIL (Check engine warning light)
      Brake
      1. Indicator or warning light comes on when turning the power switch on (IG).
      2. Indicator or warning light comes on for about 3 seconds when turning the power switch from off to on (READY).
      Slip
      ABS
      Electronically controlled brake