Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT COMBINATION METER ASSEMBLY
  1. INSPECT SPEEDOMETER

    NOTICE:
    1. The combination meter assembly receives the vehicle speed signal from the brake booster with master cylinder assembly (skid control ECU) via CAN communication. Therefore, perform the following inspection referring to values on the Data List of the brake booster with master cylinder assembly (skid control ECU) because it is the source of the vehicle speed signal.
    2. Data List values of the brake booster with master cylinder assembly (skid control ECU) are used for this inspection. Therefore, make sure to perform this inspection after confirming that DTCs are not output.
    3. If the tire size or tire inflation pressure is not within the specified range, or the tires are excessively worn, the speedometer indication error will increase. Therefore, make sure to perform this inspection after checking that the tire size, tire inflation pressure and tire wear are in the specified range.


    1. Before starting the following inspection, check if electronically controlled brake system DTCs are output.

    2. Check the values by referring to the table below.

      ABS/VSC/TRC 
      Tester Display
      Measurement Item/Range
      Normal Condition
      Diagnostic Note
      Vehicle Speed
      Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
      Vehicle stopped: 0 km/h (0 mph)
      When driving at constant speed: No large fluctuations

      Standard: km/h 
      Intelligent Tester Indication (km/h)
      Acceptable Range (km/h)
      20
      21.0 to 25.0
      40
      41.7 to 46.2
      60
      62.7 to 67.2
      80
      83.4 to 88.4
      100
      104.3 to 109.3
      120
      125.1 to 130.6
      140
      145.8 to 151.8
      160
      166.2 to 173.2
      180
      186.9 to 194.5
      200
      207.7 to 215.7
      220
      228.4 to 236.8

  1. CHECK LED ILLUMINATION (BULB CHECK)

    1. Check the illumination function of the warning or indicator lights listed below when turning the power switch on (IG).

      OK:

      Warning or Indicator Light
      Specified Condition
      Brake warning light / red (malfunction)
      1. Warning light or indicator light comes on for about 3 seconds after turning the power switch on (IG).
      2. Warning light or indicator light comes on when turning the power switch from off to on (READY) for 3 seconds, then goes off.
      Brake warning light / yellow (minor malfunction)
      Slip indicator light
      ABS warning light
      VSC OFF indicator light
      Master warning light
      Warning light comes on for about 3 seconds after turning the power switch on (IG).
      SRS warning light
      Warning light comes on for about 6 seconds after turning the power switch on (IG).
      MIL (Check engine warning light)
      Warning light comes on when turning the power switch on (IG).
      EPS warning light