Home › Engine / Hybrid System › 2AR-FXE ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE

CAMSHAFT OIL CONTROL VALVE > INSPECTION

for Preparation Click here



1. INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    6.9 to 7.9 Ω

    If the result is not as specified, replace the oil control valve assembly.



    A255142E01
  1. Connect a positive (+) lead from the auxiliary battery to terminal 1 and a negative (-) lead to terminal 2, and check the movement of the valve.
    Text in Illustration 
    *1
    Valve
    *a
    Component without harness connected
    (Camshaft Timing Oil Control Valve)
    *b
    When applied
    *c
    When cut off

    OK:
    Condition
    Specified Condition
    Auxiliary battery positive (+) voltage is applied
    Valve moves in left arrow direction shown in illustration
    Auxiliary battery positive (+) voltage is cut off
    Valve moves in right arrow direction shown in illustration

    NOTICE:
    Confirm that the valve moves freely and does not stick in any position.

    If necessary, replace the camshaft timing oil control valve assembly.

    HINT:
    Accumulation of foreign matter can cause minor pressure leaks. Minor pressure leaks will cause the camshaft to advance or retard, and this will cause a DTC to be set.