Home › Engine / Hybrid System › 2AR-FXE ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE

CAMSHAFT OIL CONTROL VALVE > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    A259744
  1. Lift the rear of the engine cover to detach the cover from the 2 pins, and then lift the front of the engine cover to detach the cover from the pin and remove the No. 1 engine cover sub-assembly.

    NOTICE:
    Attempting to disengage both front and rear clips at the same time may cause the No. 1 engine cover sub-assembly to break.



2. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY


    A259030
  1. Disconnect the oil control valve connector.

  1. Remove the bolt and oil control valve.



    A195062E06
  1. Remove the O-ring from the oil control valve.
    Text in Illustration 
    *1
    O-ring