ENGINE COOLANT TEMPERATURE SENSOR > REMOVAL |
| 1. DRAIN ENGINE COOLANT |
Loosen the radiator drain cock plug.
Remove the radiator cap sub-assembly.

| *1 | Radiator Cap Sub-assembly | *2 | Radiator Drain Cock Plug |
| 2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY |
![]() |
Lift the rear of the engine cover to detach the cover from the 2 pins, and then lift the front of the engine cover to detach the cover from the pin and remove the No. 1 engine cover sub-assembly.
| 3. REMOVE COOL AIR INTAKE DUCT SEAL |
![]() |
Remove the 9 clips and cool air intake duct seal.
| 4. REMOVE INLET AIR CLEANER ASSEMBLY |
![]() |
Remove the 2 bolts and inlet air cleaner assembly.
| 5. REMOVE ENGINE COOLANT TEMPERATURE SENSOR |
![]() |
Disconnect the ventilation hose from the cylinder head cover.
![]() |
Disconnect the engine coolant temperature sensor connector.
Remove the 2 bolts and disconnect the wire harness.
![]() |
Using a 19 mm ball joint lock nut wrench, remove the engine coolant temperature sensor.
| *1 | Ball Joint Lock Nut Wrench |
| *2 | Gasket |
Remove the gasket from the engine coolant temperature sensor.