Home › Engine / Hybrid System › 2AR-FXE ENGINE CONTROL › THROTTLE BODY

THROTTLE BODY > INSPECTION

for Preparation Click here



1. INSPECT THROTTLE WITH MOTOR BODY ASSEMBLY
  1. Check that the throttle valve opens and closes smoothly.

  1. Check that there is no sludge accumulated around the throttle with motor body assembly.



    A062403E05
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (M-) - 2 (M+)
    20°C (68°F)
    0.3 to 100 Ω

    Text in Illustration 
    *a
    Component without harness connected:
    (Throttle with Motor Body Assembly)
    If the result is not as specified, replace the throttle with motor body assembly.