THROTTLE BODY > ON-VEHICLE INSPECTION |
| 1. CHECK THROTTLE WITH MOTOR BODY ASSEMBLY |
Check the throttle control motor operating sound.
Turn the power switch on (IG).
When depressing the accelerator pedal, check the operating sound of the running motor. Make sure that no friction noises are emitted from the motor.
If friction noises exist, replace the throttle with motor body assembly.
Check the throttle position sensor.
Connect the tester to the DLC3.
Turn the power switch on (IG).
Turn the tester on.
Perform the "Inspection After Repair".
Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Throttle Sensor Position.
Depress the accelerator pedal. When the throttle valve is fully opened, check that the value of "Throttle Sensor Position" is within the specification.