Home › Engine / Hybrid System › 2AR-FXE ENGINE CONTROL › KNOCK SENSOR

KNOCK SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL KNOCK CONTROL SENSOR


    A212473E04
  1. Install the sensor with the bolt so that the sensor is angled as shown in the illustration.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

    Text in Illustration 
    *a
    Front of Engine
    *b
    Up
    *c
    7°
    *d
    10°

    NOTICE:
    The acceptable installation angle of the sensor is between 7° upward and 10° downward from the horizontal position.

    HINT:
    Perform "Inspection After Repair" after replacing the knock control sensor.
    1. w/ EGR System: (Click here)
    2. w/o EGR System: (Click here)

  1. Connect the sensor connector.



2. INSTALL INTAKE MANIFOLD
(Click here)