Home › Engine / Hybrid System › 2AR-FXE ENGINE CONTROL › ECM

ECM > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work (Click here).



2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER


    A259067
  1. Disengage the claw to remove the luggage trim service hole cover.



3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL


4. REMOVE ECM


    A254787
  1. Disconnect the 2 ECM connectors.

    1. Push in the locks on the 2 levers, raise the levers, and disconnect the 2 ECM connectors.

      NOTICE:
      After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting part of the connectors.



    A254792E01
  1. Remove the nut.

  1. Remove the screw (A).

  1. Loosen the screw (B) and remove the ECM.

  1. Remove the screw (B).



    A254793
  1. Remove the 2 screws and No. 2 ECM bracket.



5. REMOVE NO. 1 RELAY BLOCK COVER


6. REMOVE NO. 1 ECM BRACKET


    A259046
  1. Remove the nut.

  1. Release the 2 clamps and disconnect the wire harness.



    A254786
  1. Disconnect the wire harness clamp.



    A249913
  1. Remove the nut and No. 1 ECM bracket.